Siemens SINUMERIK 810D

0
08.02 Contents
0
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition 0-5
Contents
Introduction 1-13
1.1 The ManualTurn product........................................................................................... 1-14
1.2 Operator notes .......................................................................................................... 1-15
1.3 Switching on/switching off ......................................................................................... 1-16
Operation 2-17
2.1 Operator panels ........................................................................................................ 2-18
2.2 Machine control panel ............................................................................................... 2-21
2.3 Mini handheld unit ..................................................................................................... 2-25
2.4 Graphics interface ..................................................................................................... 2-27
2.5 Operating system ...................................................................................................... 2-29
2.5.1 Operating modes....................................................................................................... 2-30
2.5.2 Important function keys ............................................................................................. 2-32
2.5.3 Important soft keys.................................................................................................... 2-33
2.5.4 Pocket calculator....................................................................................................... 2-34
2.5.5 Absolute and incremental dimensions ...................................................................... 2-36
2.5.6 Angle reference system ............................................................................................ 2-37
2.5.7 Tool and cutting data................................................................................................. 2-38
Preparatory Functions for Machining 3-41
3.1 Approach reference points ........................................................................................ 3-42
3.2 Setup......................................................................................................................... 3-44
3.3 Incremental feed mode ............................................................................................. 3-45
3.4 Offsets....................................................................................................................... 3-47
3.4.1 General notes............................................................................................................ 3-47
3.4.2 Preset........................................................................................................................ 3-48
3.4.3 Manual offset............................................................................................................. 3-49
3.4.4 Delete manual offset ................................................................................................. 3-50
3.4.5 Zero offset ................................................................................................................. 3-51
3.5 Spindle speed limitation ............................................................................................ 3-52
3.6 Oriented spindle stop ................................................................................................ 3-53
3.7 C axis mode .............................................................................................................. 3-54
3.8 Tool ........................................................................................................................... 3-55
3.8.1 Enter tool offset data ................................................................................................. 3-55
3.8.2 Selecting/deselecting tool offset................................................................................ 3-57
3.8.3 Measure tool ............................................................................................................. 3-58
3.8.4 Tool wear compensation ........................................................................................... 3-60
3.9 Measuring system changeover inch/metric............................................................... 3-61