3
Preparatory Functions for Machining 08.02
3.3 Incremental feed mode
3
© Siemens AG, 2002. All rights reserved
3-46 SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
Alternative
Enter incremental dimension, e.g. 0.175.
If necessary, use the cursor keys to select the infeed speed and
overwrite the value.
Activate incremental feed by pressing NC Start key.
If required, repeat the process with the same or different values.
To deselect incremental feed mode, select the key labeled "Increment"
again.
You can interrupt axis feed at any time by pressing the Stop key or
abort the process by deselecting the axis direction.
To Next Page
Loading...
Need help?
General
