Siemens SINUMERIK 810D Operation & Programming Manual

4
Turning Simple Contours 08.02
4.2 Turnin
g
with
p
ath dimension in
p
ut
4
© Siemens AG, 2002. All rights reserved
4-68 SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
Initiate feed motion by pressing the Start key.
• The feed motion can be interrupted at any time by means of the
Stop key.
• Longitudinal turning is performed similarly to face turning
by means of soft key "Z".
b) Positioning the rotary axis (C)
C
Select the soft key for the desired axis, here the C axis.
Before entering a value, enter "abs/incr." with the "Alternat." soft key.
Enter the traversing path (incr.) or end position (abs) and confirm by
pressing the "Input" key
e.g. 30 abs.
Enter feed type (rapid traverse or mm/min) and confirm by pressing
the "Input" key
e.g. F 2 mm/min
Initiate feed motion by pressing the Start key.
The input value mm/min is traveled as °/min.

Siemens SINUMERIK 810D Specifications

General

Brand	Siemens
Model	SINUMERIK 810D
Category	Control Unit
Language	English