ï›™ Siemens AG 2000. All rights reserved
0-18
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
0
Preface 04.00
Structure of the manual
0
For your information
Your SIEMENS 840D/840Di/810D or FM-NC is state of
the art and is manufactured in accordance with
recognized safety regulations, standards and
specifications.
Additional devices
SIEMENS offers special add-on equipment, products
and system configurations for the focused expansion of
SIEMENS controls in your field of application.
Personnel
Only
specially trained, authorized and experienced
personnel
may work on the control. This applies at all
times, even for short periods.
It is necessary to clearly
define
the respective
responsibilities
of the personnel for setting up,
operation and maintenance; it is necessary to
supervise
the compliance thereof.
Actions
Before
the control is started up, it should be ensured
that the Operator' Guides have been read and
understood by the people responsible. In addition,
operation must be conducted under
constant
supervision
regarding the overall technical state (faults
and damages visible from outside, as well as changes
in operation behavior) of the control.
To Next Page
Loading...
Need help?
General
