ï›™ Siemens AG 2000. All rights reserved
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
0-19
0
04.00 Preface
Structure of the manual
0
Service
Only
qualified personnel
specifically trained for this
purpose should be allowed to perform repairs, and only
in accordance with the contents of the maintenance
guides. All appropriate safety specifications must be
observed.
Note
The following are considered
not compliant with the
usage to the intended purposes
and are therefore
excluded from all liability of the manufacturer
:
Every
usage not complying with or going beyond the
abovementioned points.
If the control is
not operated in a technically faultless
state
, if proper safety precautions are not taken, or if
the instructions in the Instruction Manual are not
complied with.
If faults which could influence safety of operation are
not remedied
before
installation and start-up of the
control.
Each
change, jumpering
or
shut-down
of devices on
the control which serve for proper functioning, universal
usage and active and passive safety.
Unforeseen dangers
can result in:
•
personal injury or death,
•
damage to the control, machine and other
possessions of the plant and user.
To Next Page
Loading...
Need help?
General
