Siemens SINUMERIK 840D - Page 489

15
12.98 Tables
15.1 List of instructions
15

Siemens AG 2000. All rights reserved
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
15-489
DEF Variable definition Integer,
without sign
DEFAULT Branch in CASE branch Jump to if
expression does
not fulfill any of the
specified values
DEFINE Define macro
DELDTG Delete distance-to-go
DELT Delete tool Duplo number can
be omitted
DIAMOF
1
Diametral programming: OFF m29
DIAMON Diametral programming: ON m29
DIAM90 Diameter program for G90, radius progr. for G91 m 29
DILF Rapid lift length m
DISABLE Interrupt OFF
DISC Transition circle overshoot in tool radius
compensation
0, ..., 100 m
DISPLOF Suppress current block display
(display OFF)
DISPR Distance path for repositioning Real,
without sign
s
DISR Distance for repositioning Real,
without sign
s
DITE Thread run-out path Real m
DITS Thread run-in path Real m
DIV Integer division
DL Tool sum compensation INT m
DRFOF Deactivate the handwheel offsets (DRF) m
DRIVE
9
Velocity-dependent path acceleration m21
DRIVEA Switch on bent acceleration characteristic curve for the
programmed axes
DZERO Set D number of all tools of the TO unit assigned to the
channel invalid
EAUTO
7
Definition of last spline segment by last 3 points (end not
a knot)
m20
EGDEF Definition of an electronic gear
(Electronic gear define)
for 1 following axis
with up to 5
leading axes
EGDEL Delete coupling definition for the following axis
(Electronic gear delete)
Triggers
preprocessing stop