15
Tables 12.98
15.1 List of instructions
15
Siemens AG 2000. All rights reserved
15-500
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
ORIWCS
1,6
Tool orientation in workpiece coordinate system m 25
OS Oscillation ON / OFF Integer,
without sign
OSC
6
Constant smoothing for tool orientation m34
OSCILL Axis assignment for oscillation –
activate oscillation
Axis: 1–3 infeed
axes
m
OSCTRL Oscillation control options Integer,
without sign
m
OSE Oscillation: End point m
OSNSC Oscillation: Number of spark-
out cycles number spark out cycles)
m
OSOF
1,6
Constant smoothing for tool orientation OFF m 34
OSP1 Oscillation: Left-hand reversal point
(oscillating: position 1)
Real m
OSP2 Oscillation: Right-hand reversal point
(oscillating: position 2)
Real m
OSS
6
Tool orientation smoothing at end of block m 34
OSSE
6
Tool orientation smoothing at beginning and end of
block
m34
OST1 Oscillation: Stop in left-hand reversal point Real m
OST2 Oscillation: Stop in right-hand reversal
point
Real m
OVR Spindle override 1, ..., 200% m
OVRA Axial spindle override 1, ..., 200% m
P Number of subprogram passes 1 ... 9999,
integer
without sign
E.g. L781 P...
; separate block
PDELAYOF
6
Delay for punching OFF (punch with delay OFF) m 36
PDELAYON
1,
6
Delay for punching ON (punch with delay ON) m 36
PL Parameter interval length Real,
without sign
s
PM per minute Feed per minute
PO Polynomial Real,
without sign
s
POLF Position LIFTFAST Real,
without sign
POLF[Y]=10 m
POLY
5
Polynomial interpolation m1
PON
6
Punching ON (punch ON) m35
PONS
6
Punching ON in IPO cycle (punch ON slow) m 35
POS Position axis POS[X]=20
POSA Position axis across block boundaries POSA[Y]=20
To Next Page
Loading...
