Siemens SINUMERIK 840D - Page 499

15
12.98 Tables
15.1 List of instructions
15

Siemens AG 2000. All rights reserved
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
15-499
NCK Specify validity range for data once per NCK
NEWCONF Accept modified machine data
NEWT Create new tool Duplo number can
be omitted
NORM
1
Normal setting at start and end points for tool offset m 17
NOT Logical NOT (negation)
NPROT Machine-specific protection zone ON/OFF
NPROTDEF
Machine-specific protection area definition
(NCK-specific protection area definition)
NUMBER Convert input string to number Real
OEMIPO1
6,8
OEM interpolation 1 m1
OEMIPO2
6,8
OEM interpolation 2 m1
OF Vocabulary word in CASE branch
OFFN Allowance for programmed contour OFFN=5
OMA1
6
OEM address 1 Real m
OMA2
6
OEM address 2 Real m
OMA3
6
OEM address 3 Real m
OMA4
6
OEM address 4 Real m
OMA5
6
OEM address 5 Real m
OFFN Offset compensation – normal Real m
OR Logical OR
ORIC
1,6
Changes in orientation at outer corners are overlaid on
the circular block to be inserted (orientation change
continuously)
m27
ORID
6
Changes in orientation are performed before the
circular block (orientation change discontinuously)
m27
ORIEULER
Orientation angles using Euler angles m50
ORIMACHA
X
Linear interpolation of machine axes or orientation axes m 51
ORIMCS
6
Tool orientation in machine coordinate system m 25
ORIRPY Orientation angles using RPY angles m50
ORIS
5
Change in orientation
(orientation smoothing factor)
Real Referred to path m
ORIVIRT1 Orientation angles using virtual orientation axes
(definition 1)
m50
ORIVIRT2 Orientation angles using virtual orientation axes
(definition 1)
m50
ORIVIRTAX
Large-circle interpolation m51