Siemens SINUMERIK 840D - Page 503

15
12.98 Tables
15.1 List of instructions
15

Siemens AG 2000. All rights reserved
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
15-503
RND Round contour corner Real,
without sign
RND=... s
RNDM Modal rounding Real,
without sign
RNDM=...
RNDM=0: M. V. deactivation
m
ROT Programmable rotation Rotation
around
1st
geometry
axis:
–180
°
..
180
°
2nd G axis:
–89.999
°
,
..., 90
°
3rd G axis:
–180
°
..
180
°
ROT X... Y... Z...
ROT RPL= ; separate
block
s3
ROUND Round decimal places Real
RP Polar radius (radius polar) Real m,s
3
RPL Rotation in plane (rotation plane) Real,
without sign
s
RT Parameter for access to frame data: Rotation
S Spindle speed or
(with G4, G96) another meaning
0.1 ...
99999999.9
Spindle speed in
rev/min
G4: Dwell time in
spindle rotations
G96: Cutting rate in
m/min
S...: Spindle speed for
master spindle
S1...: Spindle speed for
spindle 1
m,s
SAVE Attribute for saving information at subroutine calls The following are
saved: All modal G
functions and the
current frame
SBLOF Suppress single block
(single block OFF)
The following blocks
are executed in
single block like a
block.
SBLON Clear single block suppression
(single block ON)
SC Parameter for access to frame data: Scaling (scale)
SCALE Programmable scaling (scale) SCALE X... Y... Z...
; separate block
s3
SD Spline degree Integer,
without sign
s
SET Vocabulary word for initialization of all elements of an
array with listed values
SETAL Set alarm