Siemens SINUMERIK 840D

15
Tables 12.98
15.1 List of instructions
15

Siemens AG 2000. All rights reserved
15-506
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
TAN Tangent (trigon. function) Real
TANG Determine tangent for the follow-up from both specified
leading axes
TANGOF Tangent follow-up mode OFF
TANGON Tangent follow-up mode ON
TCARR Request toolholder (number "m") Integer m=0: Deselect
active toolholder
TCARR=1
TCOABS
1
Determine tool length components from current tool
orientation
Required after
resetting machine,
e.g.
m42
TCOFR Determine tool length components from orientation of
active frame
by manual setting m 42
TILT
5
Side angle Real m
TMOF Deselect tool monitoring function T number required
only if tool with this
number is not
active.
TMOF (T No.)
TMON Select tool monitoring function T No. = 0:
Deactivate
monitoring function
for all tools
TMON (T No.)
TO Defines the end value in a FOR counter loop
TOFRAME Set current programmable frame to tool coordinate
system
s3
TOLOWER Convert letters of the string into lowercase
TOUPPER Convert letters of the string into uppercase
TR Parameter for access to frame data: Translation
TRAANG Transformation inclined axis Several
transformations
settable per
channel
TRACEOF Circularity test: Transfer of values OFF
TRACEON Circularity test: Transfer of values ON
TRACON Transformation concatenated
TRACYL Cylinder: Peripheral surface transformation see TRAANG
TRAFOOF Switch off transformation TRAFOOF( )
TRAILOF Synchronous coupled motion of axes OFF
(trailing OFF)
TRAILON Synchronous coupled motion of axes ON
(trailing ON)