Siemens SINUMERIK 840D

15
04.00 Tables
15.2 List of s
y
stem variables
15

Siemens AG 2000. All rights reserved
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
15-519
Cutting edge data OEM user
Identifier Type Description: System variable/value range/index Part pro Sync O S
$TC_DPC1
REAL The type can be defined in the machine data. The default is REAL
$TC_DPC1[t,d]
With active 'Flat D number management' function, the syntax is as
follows:
$TC_DPC1[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
RW 2
$TC_DPC2
REAL The type can be defined in the machine data. The default is REAL
$TC_DPC2[t,d]
With active 'Flat D number management' function, the syntax is as
follows:
$TC_DPC2[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
RW 2
$TC_DPCi
REAL The type can be defined in the machine data. The default is REAL
$TC_DPC
i
[t,d]
With active 'Flat D number management' function, the syntax is as
follows:
$TC_DPC
i
[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
RW 2
$TC_DPC10
REAL The type can be defined in the machine data. The default is REAL
$TC_DPC10[t,d]
With active 'Flat D number management' function, the syntax is as
follows:
$TC_DPC10[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
RW 2
$TC_DPCS1
REAL The type can be defined in the machine data. The default is REAL
$TC_DPCS1[t,d]
With active 'Flat D number management' function, the syntax is as
follows:
$TC_DPCS1[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
RW 5
.
2
$TC_DPCS2
REAL The type can be defined in the machine data. The default is REAL
$TC_DPCS2[t,d]
With active 'Flat D number management' function, the syntax is as
follows:
$TC_DPCS2[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
RW 5
.
2