Siemens SINUMERIK 840D

15
04.00 Tables
15.2 List of s
y
stem variables
15

Siemens AG 2000. All rights reserved
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
15-525
Identifier Type Description: System variable/value range/index Part pro Sync O S
$TC_ECP54
REAL Offset for $TC_DP4: $TC_ECP54[t,d] analogous to $TC_DP13[t,d]
With active 'Flat D number management' function, the syntax is as
follows:
$TC_ECP54[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
RW 5
...
...
$TC_ECP61
REAL Offset for $TC_DP11: $TC_ECP61[t,d] analogous to $TC_DP20[t,d]
With active 'Flat D number management' function, the syntax is as
follows:
$TC_ECP61[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
RW 5
$TC_ECP63
REAL Offset for $TC_DP3: $TC_ECP63[t,d] analogous to $TC_DP12[t,d]
With active 'Flat D number management' function, the syntax is as
follows:
$TC_ECP63[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
RW 5
$TC_ECP64
REAL Offset for $TC_DP4: $TC_ECP64[t,d] analogous to $TC_DP13[t,d]
With active 'Flat D number management' function, the syntax is as
follows:
$TC_ECP64[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
RW 5
...
...
$TC_ECP71
REAL Offset for $TC_DP11: $TC_ECP71[t,d] analogous to $TC_DP20[t,d]
With active 'Flat D number management' function, the syntax is as
follows:
$TC_ECP71[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
RW 5