To Next Page

To Previous Page

Program Creation with EasyStep and G Code 08.02

7.10 G code

rammin

7-144 SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition

Copy

block

The soft key copies the selected block into the buffer. The block

remains stored in the buffer even after the parts program has been

changed.

Delete

block

This soft key marks the block end and deletes the block in the

program. The deleted block is stored in the buffer.

Insert

block

This soft key inserts the deleted or copied block from the buffer to the

text behind the cursor position.

Delete

NC block

An NC block is deleted.

Renumber

Specify the following values in the "Renumber" box:

• Increment for the block numbers (e.g. 1, 5, 10)

• Number of the first block

To remove the step numbering, set the increment or block number

to 0.

Searching the text

The soft key opens the "Search term" dialog box.

Enter the term you are searching for. You can set the search direction

forwards or backwards with the "Alternat." soft key.

Replace

Searches for the next of the term entered under "Search for" and

replaces it with the new term.

Siemens SINUMERIK 840D Operation & Programming Manual

Other manuals for Siemens SINUMERIK 840D