Siemens SINUMERIK 840D Operation & Programming Manual

1
08.02 Introduction
1.2 O
p
erator notes
1
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition 1-15
1.2 Operator notes
Caution
The operator panel/machine control panel may only be opened for
servicing purposes by properly qualified personnel.
Danger
Fatal injury may occur if the operator panel/machine control panel is
opened when the power supply is still connected.
Warning
Electronic components inside the operator/machine control panel may
sustain irreparable electrical damage if they are not handled in the
correct manner.
Before you touch any control elements on this operator panel:
Please read through the explanations in this document carefully!

Siemens SINUMERIK 840D Specifications

General

Series	SINUMERIK 840D
Axes	Up to 31
Channels	Up to 10
Operating System	Windows-based
Power Supply	24 V DC
Control Unit Type	CNC
Interface	Ethernet, PROFIBUS
Display	TFT color display
Interpolation	Spline
PLC	Integrated PLC
Data Storage	CompactFlash, USB