Siemens SINUMERIK 840D Operation & Programming Manual

1
Introduction 08.02
1.3 Switchin
g
on/switchin
g
off
1
© Siemens AG, 2002. All rights reserved
1-16 SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
1.3 Switching on/switching off
Function
Switching on
There are various methods by which the control system or the entire
installation can be switched on.
It is very important to read the information supplied by the machine
manufacturer!
A power-up display specific to the machine manufacturer appears
several seconds after the control has powered up.
Switching off
Before you switch off the control system or the entire installation,
please remember:
It is very important to read the information supplied by the machine
manufacturer!
n

Siemens SINUMERIK 840D Specifications

General

Series	SINUMERIK 840D
Axes	Up to 31
Channels	Up to 10
Operating System	Windows-based
Power Supply	24 V DC
Control Unit Type	CNC
Interface	Ethernet, PROFIBUS
Display	TFT color display
Interpolation	Spline
PLC	Integrated PLC
Data Storage	CompactFlash, USB