9
General Functions 08.02
9.2 Teach In
9
© Siemens AG, 2002. All rights reserved
9-164 SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
Teach
RT
Teach
F
Additional notes
You can accept the movements directly by pressing either the key
"Teach RT (rapid traverse)" or the key "Teach F (feedrate)" on the
machine control panel.
Please follow the advice of the machine manufacturer.
Slide movements in
MANUAL mode
using the control stick
Select MANUAL mode.
Select the direction (straight or conical) with the control stick.
Start the movement by pressing the "NC Start" key.
You can stop the movement by pressing the "NC Stop" key or by
returning the control stick to the center position. The movement is
stored automatically.
Programmed spindle speed values and feedrates are multiplied by the
percentage of the override switch in question at the end of a
movement and transferred to the EasyStep program.
You cannot execute the following functions when Teach In is active.
• Zero offset
• Preset
• Enter tool offset data
• Measure tool.
To Next Page
Loading...
Need help?
General
