Siemens SINUMERIK 840D

12
Examples 08.02
12.2 Exam
p
le 2: External machinin
g
with s
p
here
12
© Siemens AG, 2002. All rights reserved
12-190 SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
Result
3. Blank contour input
with contour calculator
• Call
CONTOUR mode
• Press soft key
New
contour
• Input blank contour name (here: Cont_121) and confirm
• Blank contour start point X0: 0 Z0: 0
FRCM: –
• Press soft key
• Enter the following contour elements and confirm each time by
pressing soft key
:
1. X: 60
2. Z: -60
3. X: 86
4. Z: -87
5. X: 0
6. Z: 0
Result