Siemens SINUMERIK 840DE

Programming Motion Commands
4.14 Contour definitions
Fundamentals
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
4-43
5
6WDUWSRLQW
%DVHFLUFOH
0D[
GHYLDWLRQ
(QGSRLQW
4.14 Contour definitions
4.14.1 Straight line with angle (X2... ANG...)
Function
The end point is defined through specification of
• the angle ANG and
• one of the two coordinates X2 or Z2.
;=
;=
=
;
$1*
Programming
X2… ANG…