Frames
6.6 Programmable scale factor (SCALE, ASCALE)
Fundamentals
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
6-25
Or
AROTS Z... X...
Or
CROTS Z... X...
When programming the solid angles Y and Z the new Y-axis lies in the old XY plane.
ROTS Y... Z...
Or
AROTS Y... Z...
Or
CROTS Y... Z...
Parameters
ROTS, Frame rotations with solid angles for spatial orientation of
a plane absolute, referred to the currently valid frame with
set workpiece zero for G54 to G599.
AROTS, Frame rotations with solid angles for spatial orientation of
a plane additive, referred to the currently valid frame with
set or programmed zero point.
CROTS, Frame rotations with solid angles for spatial orientation of
a plane, referred to the valid frame in the data management
with rotation in the specified axes.
X Y Z A maximum of two solid angles may be specified.
RPL Rotation in the plane: Angle through which the coordinate
system is rotated (plane set with G17-G19).
6.6 Programmable scale factor (SCALE, ASCALE)
Function
With SCALE/ASCALE you can program scale factors for all path, synchronized axes and
positioning axes in the direction of the axis specified in each case. This enables the size of a
shape to be changed. You can thus program taking similar geometrical shapes or different
shrinkages into account.
To Next Page
Loading...
