Tool offsets
8.5 Tool selection T with tool management
Fundamentals
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
8-17
Example of turning
Tool change with T command
N10 T1 D1 ;Tool T1 is replaced and activated with ;associated
D1
N11 G0 X... Z... ;The length offsets are traversed
N50 T4 D2 ;Load tool T4, D2 from T4 is active
...
N70 G0 Z... D1 ;Other cutting edge D1 is activated for tool T4
8.5 Tool selection T with tool management
Function
Tool selection T with tool management is illustrated in the sample magazine with 1 to 20
locations.
Sample magazine with 1 to 20 locations
A magazine has locations 1 to 20:
Location 1 occupied by drilling tool, duplo no.=1, T15, disabled
Location 2 is not occupied
Location 3 is occupied by drilling tool, duplo no.=2, T10, enabled
Location 4 is occupied by drilling tool, duplo no.=3, T1, active
Locations 5 to 20 are not occupied
To Next Page
Loading...
