Siemens SINUMERIK 840DE

Positional Data
3.5 Special turning functions
Fundamentals
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
3-15
3.5 Special turning functions
3.5.1 Dimensions for radius, diameter, (DIAMON, DIAMOF, DIAM90)
Function
The free choice of diameter or radius dimensions allows you to program the dimensions
straight from the engineering drawing without conversion.
=
;
'
:
',$021 ',$02)
'
=
;
5
5
:
After power up of
• DIAMON/DIAM90, diameter dimensions are defined for the specified transverse axis. as
diameter.
• DIAM90 is displayed as a diameter, irrespective of the traversing method (G90/G91) the
actual value of the transverse axis. This also applies to reading of actual values in the
workpiece coordinate system with MEAS, MEAW, $P_EP[x] and $AA_IW[x].
Programming
DIAMON
Or
DIAMOF
Or
DIAM90