Siemens SINUMERIK 840DE

Programming Motion Commands
4.14 Contour definitions
Fundamentals
4-44 Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
Parameters
X2 or Z2 End point in Cartesian coordinates X or Z
ANG Angle
Machine manufacturer
The names for angle (ANG), radius (RND) and chamfer (CHR) can be set in MD, see
/FBFA/FB ISO Dialects.
Example
N10 X5 Z70 F1000 G18 ;Approach start position
N20 X88.8 ANG=110 or (Z39.5 ANG=110) ;Straight line with specified angle
N30 ...
4.14.2 Two straight lines (ANG1, X3... Z3... ANG2)
Function
The intersection of the two straight lines can be designed as a corner, curve or chamfer. The
end point of the first of the two straight lines can be programmed by defining the coordinates
or specifying the angle.
$1*
;
=
;=
;=
$1*
;=
$1*
;
=
;=
;=
$1*
;=
&DQDOVREHUDGLXV&DQDOVREHUDGLXV
RUFKDPIHU
RU&+5RU&+5
Programming
ANG1…
X3… Z3… ANG2…