Fundamental Geometrical Principles
1.3 Position of coordinate systems
Fundamentals
1-20 Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
• align the coordinate axes parallel to the desired working plane by rotation
• and thus machine surfaces clamped in inclined positions, produce drill holes at different
angles.
• Performing multi-side machining operations.
<
;
=
;
<
=
The conventions for the working plane and the tool offsets must be observed – in
accordance with the machine kinematics – for machining operations in inclined working
planes.
For further information, please see "Selection of working plane, G17 to G19".
1.3.6 Assignment of workpiece coordinate system to machine axes
The location of the workpiece coordinate system in relation to the basic coordinate system
(or machine coordinate system) is determined by settable frames.
To Next Page
Loading...
