Tool offsets
8.16 Additive offsets
Fundamentals
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
8-69
=
;
'
''/
Location 1Location 2
Fine offset:
Location-dependent allowances can be made for over/under-dimensioning.
Parameters
Machine data are used to activate and define the number of additive offsets. Please refer to
the machine manufacturer's instructions.
Example
N110 T7 D7 ;The tool turret is positioned at location 7
;D7 and DL=1 are activated and traversed in the
next block
N120 G0 X10 Z1 ;N120
N130 G1 Z-6
N140 G0 DL=2 Z-14 ;DL=2 is activated in addition to D7 and traversed
;in the next block
N150 G1 Z-21
N160 G0 X200 Z200 ;Approach tool change point
...
8.16.2 Specify wear and setup values ($TC_SCPxy[t,d], $TC_ECPxy[t,d])
Function
Wear and setup values can be read and written via system variables and the corresponding
OPI services.
The logic is based on the logic of the corresponding system variables for tools and tool
edges.
To Next Page
Loading...
