Frames
6.7 Programmable mirroring (MIRROR, AMIRROR)
Fundamentals
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
6-29
6.7 Programmable mirroring (MIRROR, AMIRROR)
Function
MIRROR/AMIRROR can be used to mirror workpiece shapes on coordinate axes. All
traversing movements, which are programmed after the mirror call, e.g., in the subprogram,
are executed in the mirror image.
Programming
MIRROR X0 Y0 Z0 (substituting instruction programmed in a separate NC block)
Or
AMIRROR X0 Y0 Z0 (additive instruction programmed in a separate NC block)
Parameters
MIRROR Absolute mirror image with reference to the currently
valid coordinate system set with G54 to G599
AMIRROR Additive mirror image with reference to the currently
valid set or programmed coordinate system
X Y Z Geometry axis whose direction is to be changed. The value
specified here can be chosen freely, e.g., X0 Y0 Z0.
Example of mirroring milling
Program the contour shown here once as a subprogram and generate the three other
contours with a mirror operation. The workpiece zero is located at the center of the contours.
To Next Page
Loading...
