Siemens SINUMERIK 840DE

Positional Data
3.6 Zero offset (frame), G54 to G57, G505 to G599, G53, G500/SUPA
Fundamentals
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
3-19
3.6 Zero offset (frame), G54 to G57, G505 to G599, G53, G500/SUPA
Function
The settable zero offset relates the workpiece zero on all axes to the origin of the basic
coordinate system.
It is, therefore, possible to call up cross-program zero points for different fixtures with a G
command.
Milling:
=
;
<
=
;
<
*
For turning, for example, the offset value for tightening the chuck is entered in G54.