Tool offsets
8.7 Activating the active tool offset immediately
Fundamentals
8-22 Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
Programming
The following sequence usually applies:
T = "Ident" or
T = number or
T = duplo number
M06 triggers the tool change
D = offset Tool edge number 1 to n (n ≤ 12)
Selection
• With integrated tool management (inside NC)
relative D no. structure with internal reference to the associated tools
(e.g., replacement tool management and monitoring function possible)
• Without integrated tool management (outside NC)
flat D no. structure without internal reference to associated tools
Machine manufacturer
Tool management: See machine manufacturer's specifications.
8.7 Activating the active tool offset immediately
Function
MD $MM_ACTIVATE_SEL_USER_DATA can be used to define that the active tool offset
can be activated immediately if the parts program is in "stop" mode. See /FB1/, Description
of Functions, Fundamentals, K2 Axes, "Coordinate Systems..."
Danger
The offset is applied the next time the parts program is started.
To Next Page
Loading...
