Feedrate Control and Spindle Motion
7.5 Milling on turned parts (TRANSMIT)
Fundamentals
7-20 Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
Programming
TRANSMIT or TRANSMIT(n)
Or
TRAFOOF
Parameters
TRANSMIT Activates the first declared TRANSMIT function
TRANSMIT(n) Activates the nth declared TRANSMIT function; n can be up
to 2 (TRANSMIT(1) is the same as TRANSMIT).
TRAFOOF Deactivates an active transformation
Note
An active TRANSMIT transformation is likewise deactivated if one of the other
transformations is activated in the relevant channel (e.g., TRACYL, TRAANG, TRAORI).
To Next Page
Loading...
