Siemens SINUMERIK 840DE

Tool offsets
8.1 General notes
Fundamentals
8-4 Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
/
/
)
3 7RROWLS
6 &XWWLQJHGJHFHQWHU
5 5DGLXV
3
6
5
Any unneeded tool parameters must be set to "zero".
Description
Tool length compensation
This value compensates for the differences in length between the tools used.
The tool length is the distance between the toolholder reference point and the tip of the tool.
F
F
F
F
This length is measured and entered in the control together with definable wear values. From
this data, the control calculates the traversing movements in the infeed direction.