Siemens SINUMERIK 840DE

Tool offsets
8.3 Tool selection/tool call T
Fundamentals
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
8-13
T... [8-digit]
D1 D2 D3 • • • D32000
• Tabulated D No.: D1 D8
T1 D1 D2 D3 • • • D8
T2 D1
T3 D1
T6 D1 D2 D3
T9 D1 D2
D1 D3
•
•
T... D1 D2
2. Tool selection with tool management
• Free selection of D No. (flat D No.) relative to cutting edges
• Fixed assignment of D No. to the cutting edges
The tool is not active until M06 (incl. corresponding D No.).
Programming
Tx or T=x or Ty=X
Or
T0=
Or
M06F2=... to F7=...