Siemens SINUMERIK 840DE - Page 445

Tables
12.3 List of G functions/preparatory functions
Fundamentals
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
12-39
OSC # 2. Continuous tool orientation smoothing m
OSS # 3. Tool orientation smoothing at end of block m
OSSE # 4. Tool orientation smoothing at start and end of block m
Group 35: Punching and nibbling
Name No. Meaning X m/n SAG MM
SPOF# 1. Stroke/punch OFF: Stroke OFF, nibbling, punching OFF m Def.
SON # 2. Stroke ON: Nibbling ON m
PON # 3. Punch ON: Punching ON m
SONS # 4. Stroke ON slow: Nibbling ON in IPO cycle X m
PONS # 5. Punch ON slow: Punching ON in IPO cycle X m
Group 36: Punching with delay
Name No. Meaning X m/n SAG MM
PDELAYON
#
1. Punch with delay ON: Punching with delay ON m Def.
PDELAYOF
#
2. Punch with delay OFF: Punching with delay OFF m
# The vocabulary word is not valid for SINUMERIK 810D/NCU571.
Group 37: Feed profile
Name No. Meaning X m/n SAG MM
FNORM # 1. Feed normal: Feed normal (as per DIN 66025) m Def.
FLIN # 2. Feed linear: Feed linear variable m
FCUB # 3. Feed cubic: Feedrate variable according to cubic spline m
Group 38: Assignment of high-speed inputs/outputs for punching/nibbling
Name No. Meaning X m/n SAG MM
SPIF1 # 1. Stroke/punch interface 1: fast NCK inputs/outputs for punching/nibbling
byte 1
m Def.
SPIF2 # 2. Stroke/punch interface 2: fast NCK inputs/outputs for punching/nibbling
byte 2
m
Group 39: Programmable contour accuracy
Name No. Meaning X m/n SAG MM
CPRECOF 1. Contour precision OFF: Programmable contour precision OFF m Def.
CPRECON 2. Contour precision ON: Programmable contour precision ON m
#The vocabulary word is not valid for SINUMERIK NCU571.