Positional Data
3.6 Zero offset (frame), G54 to G57, G505 to G599, G53, G500/SUPA
Fundamentals
3-22 Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
<
;
*
*
*
<
0
;
0
<
;
<
;
75$16;0
N10 G0 G90 X10 Y10 F500 T1 ;Approach
N20 G54 S1000 M3 ;Call the first zero offset,
;spindle clockwise
N30 L47 ;Run program, in this case as a
subprogram
N40 G55 G0 Z200 ;Call the second zero offset
;Z via obstacle
N50 L47 ;Run program as subprogram
N60 G56 ;Call third zero offset
N70 L47 ;Run program as subprogram
N80 G53 X200 Y300 M30 ;Suppress zero offset, ;end of program
Description
Setting the offset values
On the operator panel or universal interface, enter the following values in the internal control
zero offset table:
• Coordinates for the offset
• Angle for rotated clamping and
• Scale factors if necessary
To Next Page
Loading...
