Siemens SIPROTEC 7SD610 - Page 404

A Appendix
404
7SD610 Manual
C53000-G1176-C145-4
3184 Diff: Fault detection L31 (Diff Flt.
L31)
Diff. Prot OUT * * * LED BO
3185 Diff: Fault detection L31E (Diff Flt.
L31E)
Diff. Prot OUT * * * LED BO
3186 Diff: Fault detection L23 (Diff Flt.
L23)
Diff. Prot OUT * * * LED BO
3187 Diff: Fault detection L23E (Diff Flt.
L23E)
Diff. Prot OUT * * * LED BO
3188 Diff: Fault detection L123 (Diff Flt.
L123)
Diff. Prot OUT * * * LED BO
3189 Diff: Fault detection L123E (Diff
Flt. L123E)
Diff. Prot OUT * * * LED BO
3190 Diff: Set Teststate of Diff. protec-
tion (Test Diff.)
Diff. Prot IntSP ON
OFF
**LEDFC
TN
BO 92 106 1 Yes
3191 Diff: Set Commissioning state of
Diff. (Comm. Diff)
Diff. Prot IntSP ON
OFF
**LEDFC
TN
BO 92 107 1 Yes
3192 Diff: Remote relay in Teststate
(TestDiff.remote)
Diff. Prot OUT ON
OFF
* * LED BO 92 108 1 Yes
3193 Diff: Commissioning state is
active (Comm.Diff act.)
Diff. Prot OUT ON
OFF
* * LED BO 92 109 1 Yes
3197 Diff: >Set Teststate of Diff. protec-
tion (>Test Diff. ON)
Diff. Prot SP ON
OFF
**LEDBIBO
3198 Diff: >Reset Teststate of Diff.
protec. (>Test Diff. OFF)
Diff. Prot SP ON
OFF
**LEDBIBO
3199 Diff: Teststate of Diff. prot.
ON/OFF (Test Diff.ONoff)
Diff. Prot IntSP ON
OFF
**LEDBO
3200 Diff: Teststate ON/OFF via BI
(TestDiffONoffBI)
Diff. Prot IntSP ON
OFF
**LEDBO
3215 Incompatible Firmware Versions
(Wrong Firmware)
Prot. Interface OUT ON * LED BO
3217 Prot Int 1: Own Datas received
(PI1 Data reflec)
Prot. Interface OUT ON
OFF
* LED BO
3227 >Prot Int 1: Transmitter is
switched off (>PI1 light off)
Prot. Interface SP ON
OFF
**LEDBIBO
3229 Prot Int 1: Reception of faulty data
(PI1 Data fault)
Prot. Interface OUT ON
OFF
* * LED BO 93 135 1 Yes
3230 Prot Int 1: Total receiption failure
(PI1 Datafailure)
Prot. Interface OUT ON
OFF
* * LED BO 93 136 1 Yes
3233 Device table has inconsistent
numbers (DT inconsistent)
Prot. Interface OUT ON
OFF
* LED BO
3234 Device tables are unequal (DT
unequal)
Prot. Interface OUT ON
OFF
* LED BO
3235 Differences between common
parameters (Par. different)
Prot. Interface OUT ON
OFF
* LED BO
3239 Prot Int 1: Transmission delay too
high (PI1 TD alarm)
Prot. Interface OUT ON
OFF
* LED BO 93 139 1 Yes
3243 Prot Int 1: Connected with relay
ID (PI1 with)
Prot. Interface VI ON
OFF
*
3245 > GPS failure from external
(>GPS failure)
Prot. Interface SP ON
OFF
**LEDBIBO
3247 GPS: local pulse loss (GPS loss) Prot. Interface OUT ON
OFF
**LEDBO
3248 GPS: Prot Int 1 is GPS sy-
chronized (PI 1 GPS sync.)
Prot. Interface OUT ON
OFF
**LEDBO
3250 GPS:PI1 unsym.propagation
delay too high (PI 1 PD unsym.)
Prot. Interface OUT ON
OFF
**LEDBO
No. Description Function Type
of In-
for-
matio
n
Log Buffers Configurable in Matrix IEC 60870-5-103
Event Log ON/OFF
Trip (Fault) Log On/Off
Ground Fault Log ON/OFF
Marked in Oscill. Record
LED
Binary Input
Function Key
Relay
Chatter Suppression
Type
Information Number
Data Unit
General Interrogation
www . ElectricalPartManuals . com