① Name of parameter and, if availa‐
ble, unit (alternating)
④ "EDIT" symbol (ashing)
② Enumeration arrows (for enumera‐
tions only)
⑤ Parameter value
③ Parameter ID
Figure 7-6 Example of edit view
For parameters with an associated unit, the parameter name and unit are displayed as
alternating values in ①. Example: Lower range value in °C.
See also
Disabling button lock (Page 158)
Changing parameter values
Requirement
The button lock is disabled. (Page 158)
The write protection switch is disabled. (Page 113)
User PIN is disabled. (Page 155)
Procedure
1. Navigate to the parameter view (Page 107).
2. Select the desired parameter with the or button.
Use the button to conrm.
You are in the edit view.
3. Change the parameter value with the or button.
To navigate faster, keep the or button pressed.
4. Save the change with the button.
Or, cancel the change with the button.
Operating (SITRANS TF)
7.1 Local operation
SITRANS TH100/TH320/TH420/TR320/TR420/TF320/TF420 with 4 to 20 mA/HART
Operating Instructions, 05/2020, A5E41864807-AB 111
To Next Page
Loading...
