Siemens SITRANS T Series - Mounting the SITRANS TF Dual Chamber Housing; Mounting Device to a Pole with Mounting Bracket

Procedure
1. Use a 3 mm Allen key to loosen the safety catch.
2. Unscrew the cover.
3. Remove the display from the holder.
Figure 5-6 Remove the display
4. Rotate the display in 90° increments to the desired position.
5. Mount the display once again at the desired position.
6. Screw the cover back on as far as it will go.
7. Use a 3 mm Allen key to secure the safety catch.
See also
Single chamber housing design (Page 52)
Opening the device (Page 88)
5.6 Mounting the SITRANS TF dual chamber housing
5.6.1 Mounting device to a pole with mounting bracket
Introduction
The mounting holes in the bracket ② and the device enclosure ① determine the permitted
mounting positions.
Installing/mounting
5.6 Mounting the SITRANS TF dual chamber housing
SITRANS TH100/TH320/TH420/TR320/TR420/TF320/TF420 with 4 to 20 mA/HART
70 Operating Instructions, 05/2020, A5E41864807-AB