Procedure
1. Clean the thread of the adapter and enclosure until free of dust and grease.
2. Fully insert the O-ring into the adapter.
– Make sure that the O-ring remains in the correct position ① during installation of the
adapter.
3. Apply the screw retainer nish to the thread of the adapter.
4. Turn the adapter clockwise by hand until tight.
5. Tighten the adapter with a torque of 5 Nm (+1).
6. If necessary, adjust the position of the adapter until it is mounted in the following position:
Installing/mounting
5.8 Mount adapter for connector socket Han7D/Han8D
SITRANS TH100/TH320/TH420/TR320/TR420/TF320/TF420 with 4 to 20 mA/HART
Operating Instructions, 05/2020, A5E41864807-AB 75
To Next Page
Loading...
