TC35i AT Command Set
8.8 AT^MONP
s
m
obil
e
TC35i_ATC_V02.07 Page 204 of 439 1/30/04
Confidential / Released
there are several constraints to be considered:
- Only neighbour cells that have already been visible in IDLE mode will be further updated, as long as they
are still included in the list.
- Though new neighbour cells can be added to the list (e.g. due to handover), their C1 and C2 parameters
cannot be displayed until the connection is released. In this case "-" is presented for C1 and C2.
- To some extent, the cell monitoring command
AT^SMONC covers the same parameters. The receiving
level, for example, can be queried with both commands. Yet the resulting values may be slightly different,
even though obtained over a time period of a few seconds. This is quite normal and nothing to worry about,
as the cell information is permanently updated.
- For compatibility with earlier products and to support legacy applications, any input character may be used
to stop the output in certain cases (depending on the settings of Chapter 4.10, page 100 and Chapter 4.11,
page 103).
8.8.1 AT^MONP responses
Response of AT^MONP (Example):
chann rs dBm MCC MNC BCC C1 C2
653 26 -84 262 07 0 22 22
660 20 -90 262 07 3 16 16
687 19 -91 262 07 1 15 15
678 14 -96 262 07 3 10 10
671 14 -96 262 07 1 10 10
643 10 -100 262 07 7 6 6
Column Description
Chann ARFCN (Absolute Radio Frequency Channel Number) of the BCCH carrier
rs RSSI value 0 - 63 (RSSI = Received signal strength indication)
dBm Receiving level in dBm
MCC Mobile Country Code (first part of the PLMN code)
MNC Mobile Network Code (second part of the PLMN code)
BCC Base Station colour code
C1 cell selection criterion
C2 cell reselection criterion
To Next Page
Loading...
Need help?
General
