Siemens TC35i Terminal

TC35i AT Command Set
17.2 ATS3
s
m obil e
TC35i_ATC_V02.07 Page 411 of 439 1/30/04
Confidential / Released
17.2 ATS3 Write command line termination character
Syntax
Command Description
This parameter setting determines the character recognized by TA to terminate an incoming command line.
Parameter Description
command line termination character
000...13
(&F)
...127
Note
• Using other value than 13 may cause problems when entering commands.
Read Command
ATS3?
Response(s)
<n>
OK
Write Command
ATS3=<n>
Response(s)
OK
PIN ASC0 MUX1 MUX2 MUX3
! % % % %
Reference(s)
V.25ter
<n>
(num)(&W)(&V)