TC35i AT Command Set
2.13 AT+CSCS
s
m
obil
e
TC35i_ATC_V02.07 Page 51 of 439 1/30/04
Confidential / Released
2.13 AT+CSCS Select TE character set
Syntax
Command Description
Write command informs TA which character set <chset> is used by the TE. TA is then able to convert character
strings correctly between TE and ME character sets.
Parameter Description
“GSM“
(&F)
GSM default alphabet (GSM 03.38 subclause 6.2.1);
Note: This setting may cause software flow control problems since the codes
used to stop and resume data flow (XOFF = decimal 19, (XON = decimal 17)
are interpreted as normal characters.
“UCS2“ 16-bit universal multiple-octet coded character set (ISO/IEC10646 [32]); UCS2
character strings are converted to hexadecimal numbers from 0000 to FFFF;
e.g. "004100620063" equals three 16-bit characters with decimal values 65, 98
and 99, $(AT R97)$
Test Command
AT+CSCS=?
Response(s)
+CSCS: (list of supported<chset>s)
OK
Read Command
AT+CSCS?
Response(s)
+CSCS: <chset>
OK
Write Command
AT+CSCS=[<chset>]
Response(s)
OK
PIN ASC0 MUX1 MUX2 MUX3
! % % % %
Reference(s)
GSM 07.07, GSM 11.11
<chset>
(str)
To Next Page
Loading...
