Siemens TC35i Terminal

TC35i AT Command Set
10.25 AT+FTH
s
m obil e
TC35i_ATC_V02.07 Page 270 of 439 1/30/04
Confidential / Released
10.25 AT+FTH Transmit Data Using HDLC Framing
Syntax
Command Description
This command causes the TA to transmit data using HDLC protocol and the modulation mode defined below. An
ERROR response code results if this command is issued while the modem is on-hook
Notes
• Used for Fax Class 1 only
•Only
<mod>= 3 is possible
Write Command
AT+FTH=<mod>
Response(s)
CONNECT
PIN ASC0 MUX1 MUX2 MUX3
! % % ! !
Reference(s)
TIA/EIA-578