Siemens TC35i Terminal User Manual

TC35i AT Command Set
15.15 AT^SNFS
s
m obil e
TC35i_ATC_V02.07 Page 385 of 439 1/30/04
Confidential / Released
15.15 AT^SNFS Select audio hardware set
Syntax
Command Description
The write command serves to set the audio mode required for the connected equipment. For use after restart of
the module, you are advised to store the selected mode to the audio profile set with
AT^SNFW. Otherwise, audio
mode 1 will be active each time the module is powered up.
AT^SNFS can also be used in conjunction with AT^SAIC. This is useful, for example, if both interfaces are oper-
ated alternatively to benefit from different devices. Each audio mode can be assigned a specific interface. To do
so, first select the audio mode with
AT^SNFS, then activate the audio interface with AT^SAIC and finally enter
AT^SNFW to store the settings to your audio profile. To switch back and forth it is sufficient to use AT^SNFS.
Test Command
AT^SNFS=?
Response(s)
^SNFS: (list of supported <audMode>s)
OK
Read Command
AT^SNFS?
Response(s)
^SNFS: <audMode>
OK
Write Command
AT^SNFS=<audMode>
Response(s)
OK
ERROR
CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3
! % % % %
Reference(s)
SIEMENS

Siemens TC35i Terminal Specifications

General

Brand	Siemens
Model	TC35i Terminal
Category	Modem
Language	English