TC35i AT Command Set
15.15 AT^SNFS
s
m
obil
e
TC35i_ATC_V02.07 Page 386 of 439 1/30/04
Confidential / Released
Parameter Description
[1] Audio mode 1: Standard mode optimized for the reference handset, that can
be connected to the analog interface 1 (see your "Hardware Interface Descrip-
tion" for information on this handset.) To adjust the volume use the knob of the
reference handset. In audio mode 4, this handset can be used with user
defined parameters.
Note: The default parameters are determined for type approval and are not
adjustable with AT commands.
AT^SNFD
restores <audMode>
1. 2 Audio mode 2: Customer specific mode for a basic handsfree device (Siemens
Car Kit Portable).
Analog interface 2 is assumed as default.
3 Audio mode 3: Customer specific mode for a mono-headset.
Analog interface 2 is assumed as default.
4 Audio mode 4: Customer specific mode for a user handset.
Analog interface 1 is assumed as default.
5 Audio mode 5: Customer specific mode.
Analog interface 1 is assumed as default.
6 Audio mode 6: Customer specific mode.
Analog interface 2 is assumed as default.
Notes
• The write command can be used during a voice call to switch back and forth between different modes. This
allows the user, for example, to switch handsfree operation on and off.
• Users should be aware that
<outStep> is a global setting. This means, when another audio mode is selected
during a call, the value of
<outStep> does not change. This is also true for mute operation which can be set
with
AT^SNFM or AT+CMUT: If the microphone is muted and the user selects another audio mode during the
call, then the microphone remains muted until explicitly changed. Exception: In audio mode 1
<outStep>=4
is fix.
<audMode>
(num)(^SNFW)
To Next Page
Loading...
Need help?
General
