Siemens TC35i Terminal

TC35i AT Command Set
4.6 ATE
s
m obil e
TC35i_ATC_V02.07 Page 93 of 439 1/30/04
Confidential / Released
4.6 ATE Enable command echo
Syntax
Command Description
This setting determines whether or not the TA echoes characters received from TE during command state.
Parameter Description
[0] Echo mode off
1
(&F)
Echo mode on
Note
• In case of using the command without parameter, <value> is set to 0.
Exec Command
ATE[<value>]
Response(s)
OK
PIN ASC0 MUX1 MUX2 MUX3
! % % % %
Reference(s)
V.25ter
<value>
(num)(&W)(&V)