TC35i AT Command Set
10.13 AT+FDT
s
m
obil
e
TC35i_ATC_V02.07 Page 258 of 439 1/30/04
Confidential / Released
10.13 AT+FDT Data Transmission
Syntax
Command Description
This command requests the ME to transmit a Phase C page. When the ME is ready to accept Phase C data, it
issues the negotiation responses and the CONNECT result code to the application.
In Phase B, the
AT+FDT command releases the ME to proceed with negotiation, and releases the DCS message
to the remote station. In Phase C, the
AT+FDT command resumes transmission after the end of a data stream
transmited before.
Note
• Used for Fax Class 2 only
Exec Command
AT+FDT
Response(s)
CONNECT
Write Command
AT+FDT=<df>, <vr>, <wd>, <ln>
Response(s)
CONNECT
PIN ASC0 MUX1 MUX2 MUX3
! % % ! !
Reference(s)
EIA PN-2388
To Next Page
Loading...
