Siemens TC35i Terminal

TC35i AT Command Set
10.11 AT+FDIS
s
m obil e
TC35i_ATC_V02.07 Page 256 of 439 1/30/04
Confidential / Released
10.11 AT+FDIS Query or set session parameters
Syntax
Command Description
This command allows the controlling application to sense and constrain the capabilities used for the current ses-
sion. It uses
AT+FDIS to generate DIS or DTC messages directly, and uses AT+FDIS and received DIS mes-
sages to generate DCS messages.
Note
• Used for Fax Class 2 only
Test Command
AT+FDIS=?
Response(s)
(list of <vr>s), (list of <br>s), (list of <wd>s), (list of <ln>s), (list of <df>s), (list of <ec>s), (list of <bf>s),
(list of
<st>s)
OK
Read Command
AT+FDIS?
Response(s)
<vr>, <br>, <wd>, <ln>, <df>, <ec>, <bf>, <st>
OK
Write Command
AT+FDIS=<vr>, <br>, <wd>, <ln>, <df>, <ec>, <bf>, <st>
Response(s)
OK
PIN ASC0 MUX1 MUX2 MUX3
! % % ! !
Reference(s)
EIA PN-2388