TC35i AT Command Set
11.6 AT+CMGR
s
m
obil
e
TC35i_ATC_V02.07 Page 285 of 439 1/30/04
Confidential / Released
Command Description
The write command returns SMS message with location value <index> from message storage <mem1> to the
TE. If status of the message is 'received unread', status in the storage changes to 'received read'.
Notes
• Response if AT+CMGR is used to read an empty record index: +CMGR: 0,,0
• Response if
AT+CMGR is used to read a non-existent record index: +CMS ERROR: invalid memory index
• The parameters
<ra> and <tora> will only be displayed if parameter <ra> of the AT^SSCONF command is
set to 1.
• Filler "FF" will not be displayed in PDU status reports if parameter
<ff> of the AT^SSCONF command is set
to 1.
• This command can be used only after the SMS data from the SIM have been read successfully for the first
time. Reading starts after successful SIM authentication has been performed, and may take up to 30 seconds
depending on the SIM used. While the read process is in progress, an attempt to use any of the SMS read
commands will result in ''+CME Error: 14'' (SIM busy)
• We recommend to take advantage of the "^SSIM READY" URC. If enabled with
AT^SSET, this URC acknowl-
edges to the user that SIM data is accessible after SIM PIN authentication. It will be delivered once the ME
has completed reading data from the SIM card.
PIN ASC0 MUX1 MUX2 MUX3
% % % % %
Reference(s)
GSM 07.05
To Next Page
Loading...
Need help?
General
