TC35i AT Command Set
11.10 AT+CNMA
s
m
obil
e
TC35i_ATC_V02.07 Page 292 of 439 1/30/04
Confidential / Released
Notes
• The execute / write command shall only be used when AT+CSMS parameter <service> equals 1 (= phase
2+).
• Both the execute and the write command can be used no matter whether text mode or PDU mode is activated.
• If multiplex mode is activated (
AT+CMUX=0) the AT+CNMI parameter will be set to zero on all channels, if one
channel fails to acknowledge an incoming message within the required time.
To Next Page
Loading...
