TC35i AT Command Set
15.12 AT^SNFM
s
m
obil
e
TC35i_ATC_V02.07 Page 381 of 439 1/30/04
Confidential / Released
• This command can be used in all audio modes (1 to 6) and during a voice call only. See AT^SNFS for more
details on the various audio modes.
• During an active call, users should be aware that when they switch back and forth between different audio
modes (for example handsfree on/off) the value of
<mute> does not change, i.e. the microphone mode is
retained until explicitly changed.
• As alternative, you can use the
AT+CMUT command.
To Next Page
Loading...
Need help?
General
