TC35i AT Command Set
15.16 AT^SNFV
s
m
obil
e
TC35i_ATC_V02.07 Page 390 of 439 1/30/04
Confidential / Released
Notes
• The read and write commands refer to the active audio mode.
• The write command works only in audio modes 2 to 6!
• Any change to
<outStep> takes effect in audio modes 2 to 6. That is, when you change <outStep> and
then select another mode with
AT^SNFS, the same step will be applied. Nevertheless, the actual volume can
be quite different, depending on the values of
<outCalibrate> set in each mode. The only exception is
audio mode 1 which is fixed to
<outStep>=4.
•
<outStep> is stored non-volatile when the ME is powered down with AT^SMSO or reset with AT+CFUN=1,1.
<outStep> is not stored by AT^SNFW.
•
<outStep> can also be changed by AT^SNFO (Chapter 15.13, page 382) and AT+CLVL (Chapter 15.4, page
367).
To Next Page
Loading...
