TC35i AT Command Set
18.2 List of *# Codes
s
m
obil
e
TC35i_ATC_V02.07 Page 417 of 439 1/30/04
Confidential / Released
Possible responses
For the exact specification of the format and parameters for *# strings, please refer to GSM 02.30, Annex C, and
GSM 02.04, Table 3.2.
Function of *# codes for Supplementary Services:
BS Basic service equivalent to parameter
class:
Voice
FAX
SMS
SMS+FAX
Voice+FAX
Voice+FAX+SMS
Data circuit asynchron
Data circuit synchron
PAD
Packet
Data circuit asynchron+PAD
Data circuit synchron+Packet
Data circuit asynchron+synchron+PAD
All Services
11
13
16
12
19
10
25
24
27
26
21
22
20
--
T Time in seconds In contrast to AT Command AT+CCFC,
parameter T has no default value. If T is not
specified, an operator defined default or
the last known value may be used, depend-
ing on the network operator.
PW Password --
C Character of TE character set (e.g. aster-
ics, hash or digit in case of USSD, or digits
in case of held calls or multiparty calls)
--
Parameter Meaning
<m> Mode: 0 = not active, 1 = active
<n> Unsolicited result code: 0 = presentation disabled, 1 = presentation enabled
<status> Status: 0 = not active, 1 = active
<class> Represents BS = basic service. See Chapters AT+CCFC, AT+CLCK and 1.5.1.
<fac> Facility lock. See Chapter AT+CLCK.
<reason> Call forwarding reason
*# Code Abbreviations used in Chapter List of *# Codes Function
* act Activate (except for CLIR, see list above)
** reg Register and activate
*# int Check status (interrogate)
Abbreviation Meaning Value
To Next Page
Loading...
Need help?
General
